If pressure sensors, pressure transmitters along with other field equipment are employed near flammable gases or dust, they may be subject to marking relative to the ATEX product guideline 94/9/EC. ราคาเกจวัดแรงดันลม requires the sort label of the sensor to add the ATEX marking, so usually that is labelled directly onto the sensor during production.
Next to the Notified Body and the approval number, the marking of pressure sensors also contains important information for the user. For instance, an ?X? after the approval number indicates that special conditions must be observed with all the device. They are either given in the approval document and in the corresponding manual. Most importantly, marking according to ATEX gives information on the possible areas of application and the sort of protection used for the pressure sensor:
Explosion group:
I Mining industry, II the areas useful Device class:
Used in zone 0/20 near von flammable gases (1G), dust (1D)
Use in zone 1/21 in the vicinity of flammable gases (2G), dust (2D)
Used in zone 2/22 in the vicinity of flammable gases (3G), dust (3D)
However, there are also devices where only certain parts may be installed in other zones, for example, a pressure sensor marked 1/2G could be installed in a tank with flammable content. The electronic area of the transmitter is located on the outside of the tank, and thus in zone 1.
Examples for types of protection:
i intrinsic safety (Limitation of electrical ignition energy by limiting current and voltage)
ia for Zone 0 or Zone 20 (for Zone 20 also iaD)
ib for Zone 1 or Zone 21 (for Zone 21 also ibD)
ic for Zone 2 d
flameproof / explosion proof enclosure, suitable for zone 1/21 and 2/22 n
non-incendive, ideal for zone 2/22 m
encapsulation suitable for zone 1/21 and 2/22 Gas group and temperature class: i.e. IIC T1 for hydrogen
Note:
Further information about hydrogen can be found on the WIKA website. Assuming you have any further questions, your contact will gladly help you.